Calandra Racing Concepts Gen-X 10 Manual de montaje - Página 16

Navegue en línea o descargue pdf Manual de montaje para Coche de juguete motorizado Calandra Racing Concepts Gen-X 10. Calandra Racing Concepts Gen-X 10 19 páginas.

Imprimir página

4-40 x 1/8"

Set Screw

Bag 10

Adjust body height

by raising or

lowering this collar

Red Socket Cap

Bag 11

Battery Tray

Bolts Here

M3 x 8mm Steel

Button Head

4-40 x 3/8"

3/16" Shim

100

1 - Use the 4-40 x 3/8" red cap head screws [78] to bolt the

rear wheels to the hubs.

(Tires not included)

2 - Insert the flanged bearings [101] into the front wheels.

Place a 3/16" shim [100] over the axle, then the front wheel,

& then a red locknut [9] last. The front wheels should spin

very free. Do not over-tighten the front wheel nuts so that the

bearings are pinched.

3 - Install the battery tray [103] using four 4-40 x 1/4" steel

FH screws [102].

(The tray for NiCd/NiMh batteries is shown in the

picture. Also included is a flat LiPo battery tray.)

101

100

4-40 x 3/8"

Red Socket Cap

ODY

OSTS

1 - Secure the shorter front body posts [96] to the front bumper with

the steel button head screws [97].

2 - Mount the longer rear body posts [98] to the Tweak Plates, using

the red socket cap screw [78]. The tweak plates have two body

mount locations to accommodate numerous body sizes and styles.

Choose the hole that will work best with your body.

3 - Thread the 1/8" set screw [45] into the plastic collars [99]. Adjust

the collar up and down the body post to accommodate the body shell

used. Lock the collar with the set screw.

3/16" x 5/16"

Flanged Bearing

Red Locknut

101

Two rear body

mount locations

4-40 x 1/4"

Steel FH

102

103

102