ABB EBN853 Instrucción - Página 15
Navegue en línea o descargue pdf Instrucción para Unidad de control ABB EBN853. ABB EBN853 18 páginas. Power electronic units for field installation. for the control of contrac actuators of the pme, lme, rhd or rsd series
También para ABB EBN853: Manual de instrucciones (17 páginas)
Imprimir página
11. Alarms / Failures
11.1 Definition
11.1.1
Alarms
The actuator / electronic unit is exposed to critical conditions (e. g. high temperature) which currently
do not affect the actuator, the electronic unit, the process or persons. The actuator functions are still
available. Previous alarms are saved in the „Saved Alarms" memory of the electronic unit. Use the con-
figuration software to display the current and saved alarms.
11.1.2
Failures
The actuator / electronic unit is exposed to critical conditions (e. g. setpoint monitoring signal) which
instantly might affect the actuator, the electronic unit, the process or persons. The actuator will be
switched off and the actuator functions are no longer available. Previous failures are saved in the
„Saved Failures" memory of the electronic unit. Use the configuration software to display the current
and saved failures. Failure messages can not be reset as long as the reason for the failure exists.
11.2 Alarm scheme
setpoint monitoring
upper limit
lower limit
monitoring
ON
&
actuator
stop
safety pos.
last setpoint
Fig. 14:
transmitter
maintenance
monitoring
upper limit
lubricants / elastom.
lower limit
motor / gearing
process contr.
ON
&
Alarm Signal
temperature
temperature
actuator
electronics
(high / low)
(high / low)
behav. at crit.
temp.
MAN
AUT
&
&
actuator runs
in selected
mode
saved alarms
(reset option)
15