Whirlpool AKR 811 WH Instrucciones importantes de seguridad Manual - Página 7
Navegue en línea o descargue pdf Instrucciones importantes de seguridad Manual para Campana de ventilación Whirlpool AKR 811 WH. Whirlpool AKR 811 WH 7 páginas. 85cm "glamour" flat screen hood in white akr 811 wh
DESCRIPTION AND USE OF THE HOOD
1. Control panel.
2. Grease filter.
3. LEDs.
4. Front panel.
Control panel
T1. Motor ON/OFF
Press key T1 and the hood switches from OFF status to speed 1.
Press key T1 during operation at any speed and the hood switches to OFF status.
T2. Speed timing
Speed timing is enabled by pressing key T2; the hood switches off at the end of the time.
Operation times are as follows:
Speed 1 - 20 minutes (LED 1 blinking)
Speed 2 - 15 minutes (LED 2 blinking)
Speed 3 - 10 minutes (LED 3 blinking)
Speed 4 - 5 minutes (LED 4 blinking)
Press key T4 during timed operation and the hood exits timed mode and decreases the speed.
Press key T3 and the hood exits timed mode and increases the speed.
Press key T2 and the hood exits timed mode maintaining the set speed.
T3. Increase speed
Press key T3 during operation and the motor speed increases from minimum to maximum.
The corresponding LEDs light up at each speed:
Speed 1 LED1
Speed 2 LED1 + LED2
Speed 3 LED1 + LED2 + LED3
Speed 4 LED1 + LED2 + LED3 + LED4
T4. Decrease speed
Press key T4 during operation and the motor speed decreases.
T5. Lights ON/OFF
T6. Carbon filter signalling
Key T6 lights up (red) after 160 hours of operation. This indicates that the carbon filter installed needs to be replaced.
To reset the signalling, keep key T6 pressed for 4 seconds.
The signalling will stop and the hood will switch to OFF status.
IMPORTANT: When using the hood in extractor version it is necessary to disable carbon filter signalling.
Deactivating carbon filter signalling:
Switch the hood to OFF status and keep key T2 pressed for 4 seconds; a beep will sound.
Activating carbon filter signalling:
Switch the hood to OFF status and keep key T2 pressed for 4 seconds; a beep will sound and key T4 will blink for 3 seconds.
IMPORTANT: Condensation may form on the front surface of the hood when cooking food with the hob switched on. In this case, clean the
surface of the hood with a damp cloth after cooking.
4
2
GB14
1
3
T1
T2
T3
led 1
led 2
led 3
led 4
T4
T5
T6