Whirlpool AKR602ELIX Manual de instalación y montaje - Página 10

Navegue en línea o descargue pdf Manual de instalación y montaje para Campana de ventilación Whirlpool AKR602ELIX. Whirlpool AKR602ELIX 37 páginas.

Do not connect the appliance to the mains power supply until installation has been completed.

1. Mark a line on the wall, from the cooktop right up to the ceiling, corresponding to the centre-line of the hood.

2. Bearing in mind the minimum heights over the cooktop specified above, mark the height of the hood on the wall with a

pencil. Apply the drilling template to the wall over this mark.

3. Using the template supplied, mark the holes, drill them and insert the rawlplugs, then fit the 2 hooks (if provided) or partly

screw in 2 screws in the top holes.

4. Hang the hood and adjust the position with the hook adjustment screws (if supplied).

Note: The hood MUST be fixed with another 2 screws to be inserted in the bottom holes and (if provided for) with 2

screws in the top holes.

5. Only for some models: Mark the bottom (and top) holes, remove the hood, drill, insert the plugs

(partially screw 2 screws in the top holes).

6. Fix the flue support to the wall as close as possible to the ceiling. For the filter version, in this phase also fix the deflector F1

with 2 screws if the flue has grilles at the top (for flues with bottom grilles, see installation step "7").

7. Hang the hood on the wall again and fix in place with the screws. For the filter version (flues with bottom grilles), the

deflector F2 must be fixed in place of the coupling ring (model with fixing with 2 screws) or fitted on the coupling ring

(model with 2 rear slots and 1 front fixing screw).

Extractor Version: Fumes are extracted and expelled to the outside through a fume hose fixed to the collar at the top of the

hood.

Important: If the hood is has a carbon filter fitted, the filter must be removed.

Filter Version: Air is filtered through a carbon filter and recycled into the surrounding environment.

Important: Caution! If the hood is not equipped with a carbon filter, one must be ordered and fitted before use.

Installing the electronic control box

• If your hood has an electronic control box, S2 click it into its housing S1 and fix it in place with one screw.

• On models with electronic control panels, fit the card S3 in the socket alongside the control box S2.

Telescopic flue installation

• Connect the hood to the mains supply and fix the telescopic flue to the flue bracket with two screws. Slide the bottom

section down into its seat on the top of the hood. Fit the side grilles if provided.

5019 318 33287

* Only on some models