Whirlpool RH4830XLQ1 Manual de uso y mantenimiento - Página 5
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Campana de ventilación Whirlpool RH4830XLQ1. Whirlpool RH4830XLQ1 10 páginas. 30/36" (76.2/91.4 cm) convertible range hood installation instructions
También para Whirlpool RH4830XLQ1: Lista de piezas (1 páginas)
Imprimir página
®Fromthe diagramsbelow,
sebct the diagramfor your
instalhtion.
Vented
installations: Cut the vent
system and electrical wiring
access hobs as required.
Either
wiring
hob can be used.
Non=vented
installations:
Cut only
the one 1=1/4" (3.2 cm) dia. wiring
access hob required,
if wiring
through
the top, use Iocadon
shown in VERTICAL vent systems.
if wiring
through
the back, use
location
shown in HORIZONTAL
vent system.
Prepare and install
the hood
Excessive
Weight Hazard
Use two or more people to move
and install range hood.
Failure to do so can result in
back or other injury.
Vertical rectangular
vent:
Attach the damper/vent
connection
with two screws as
shown.
Insert
damper/vent
connection
through
wall
cutout
and
into
vent
5-1/2"
1-1/2"
waH
1-1/4"
(14 sin)
(3,8 cm)
(3.2 era)
2"
alia, ho_e (5.1 era)
3-1/4" x 10" (8.3 x 25.4 cm)
RECTANGU LAR VERTICAL
vent system
center,ins.
8" [20,3 sin)
_._
7-1/2"
wall
5"
1-1/4"
2 _Y
(12_7 sin)
(3.2 sin)
dia, ho_e
(&l
sm)
7" (17.8 cm)
vent system
centerHne
(1&1 sin)
3ol/4" x 10" (8.3 x 25.4 cm)
vent system
® Remove terminal
box cover.
Depending
on your installation,
remove either back or top wiring
knockout.
Remove the rectangular
damper/vent
connector
from
under the left side of hood. Set
connector
and screws aside for
use if connecting
to a rectangular
vent system.
For vented installations, go to
Step 7a.
For non-vented
installations,
go to Step 7e.
bumps
J_
F___X
/baffle
7a
[] For vented installations:
Insert the baffle plate into slot
behind grille.The
Iocator bumps
should be at the top as shown.
Remove either top or rear
rectangular
vent knockout.
If
using round vent, remove both
top rectangular
and semi-circular
knockouts.
7C[]
Horizontal
rectangular
vent: Attach damper/vent
connection
to back of hood and
insert through
the wall cutout and
into the horizontal
vent.
Note: if the wall cap is directly
behind the vent connector,
the
dampers
in the wall connector
and cap MUST NOT interfere with
each other. Remove the vent
connector
damper if they interfere.
Vertical round vent:
Fasten the round adapter to the
hood with two screws as shown.
Install round damper
(purchased
separately).
7e[]
For non-vented
installations: Check that the baffle
plate has not been installed
in
slot behind grille, if it has,
remove the baffle plate