Whirlpool UXD8630DYS Instrucciones de instalación y manual de uso y mantenimiento - Página 13

Navegue en línea o descargue pdf Instrucciones de instalación y manual de uso y mantenimiento para Campana de ventilación Whirlpool UXD8630DYS. Whirlpool UXD8630DYS 36 páginas. 30 76.2 cm and 36 91.4 cm retractable pop-up downdraft vent system
También para Whirlpool UXD8630DYS: Instrucciones de instalación y manual de uso y mantenimiento (44 páginas), Instalación Instrucciones de uso y cuidado (40 páginas)

Whirlpool UXD8630DYS Instrucciones de instalación y manual de uso y mantenimiento
2. Remove 4 screws attaching the terminal box cover.
A
A. Terminal box cover
3. Determine which direction (front or rear) the home power
supply cable will enter the terminal box. Remove the
appropriate knockout from the front or rear panel and install a
¹⁄₂" (12.7 mm) UL listed or CSA approved conduit connector.
4. Using 2 or more people, insert the downdraft vent into the
countertop cutout. Position downdraft vent so it is centered
in the cutout with the rear flange over the edge of the cutout
and the rear of the vent box against the edge of the cutout.
G
F
A. Rear flange of downdraft vent
B. Edge of cutout in countertop
C. Rear of downdraft vent
A
B
C
D
E
D. Cabinet back
E. Lower support leg
F. Cabinet floor
G. Countertop
5. Drill 2 pilot holes through each of the undercounter mounting
brackets into the underside of the countertop. Using 2 screws
(not provided) of the appropriate length, mount the brackets
to the countertop.
IMPORTANT: Select a screw length that will not allow the
screws to go through the countertop when tightened.
B
A. Screws
B. Backsplash
C. Countertop
6. Check that the downdraft vent is level vertically. Loosen the
lower support legs screws and position the legs against the
cabinet floor.
7. Fasten the lower support legs to the cabinet floor with screws
(not provided).
A. Screw (not provided)
8. Tighten the lower support legs screws.

Make Electrical Connections

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
C
A
A
13