Whirlpool UXI1200DYS Manual de instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Campana de ventilación Whirlpool UXI1200DYS. Whirlpool UXI1200DYS 20 páginas. 600 cfm and 1200 cfm in-line blowers for range hoods
También para Whirlpool UXI1200DYS: Dimensiones del producto (1 páginas)
Imprimir página
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Drill
•
1W' (3 cm) drill bit
•
3/lo" (0.5 cm) drill bit
•
Pencil
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Pliers
•
Caulking gun and weatherproof
caulking compound
•
Vent clamps
•
Jigsaw or keyhole saw
•
Flat-blade screwdriver
•
Metal snips
•
Phillips screwdriver
Parts needed
•
1/2"(1.3 cm) UL listed or CSA approved wiring conduit and
connectors
•
6 - 18 AWG wires, one each of the following colors: black,
white, red, blue, gray, and green or green/yellow (ground)
NOTE: The length of the conduit and 18 AWG wires is
determined by the distance between the in-line blower motor
and range hood terminal boxes.
11 - UL listed wire connectors
1/2"(1.3 cm) UL listed or CSA approved strain relief
Parts supplied
Remove parts from packages. Check that all parts are included.
•
4- 6 x 80 mm mounting screws
•
4- flat washers
•
6-wire connector assembly for range hood
•
2 - strain relief connectors
•
T-20 TORX®t adapter
IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the in-line blower motor
system.
All openings in the ceiling and wall where the in-line blower motor
system will be installed must be sealed.
For Mobile Home Installations
The installation of this in-line blower motor system must conform
to the Manufactured
Home Construction
Safety Standards, Title
24 CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction
and Safety, Title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.
Product Dimensions
Top (outlet) view
243/4'' (62.9 crn)
(20.0 cm)
33/8,,
12W_d'
(32.9 crn)
14_J/16 ''
(37.3 crn)
26V8" (66.4 crn)
Bottom (inlet) view
16V8" (41.0 crn)
33/8"
(8.6cm)
I"®TORX is a registered trademark
of Saturn Fasteners,
Inc.