Clare Controls CM-BT10-TXRX100 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Extensor Clare Controls CM-BT10-TXRX100. Clare Controls CM-BT10-TXRX100 20 páginas. Clare controls cm-bt10-txrx100 hdbaset extender set 100m

Imprimir página

Product appearance

Figure 1: The Tx100 transmitter
(1) ON
(2) LINK
(3) IN
(4) POWER LED
(5) ETHERNET
(6) HDBT OUT
(7) HDMI IN
(8) IR IN
(9) IR OUT
(10) RS-232
(11) 24 VDC
2
(1) (2) (3) (4)
Working status indicator of this device. When the transmitter is on and
working properly, the green LED blinks.
HDBaseT link status indicator, green LED. It remains illuminated when
the device has a connection.
The LED remains illuminated when connected to a device that supports
HDCP and is working normally. The LED blinks when the device does
not support HDCP.
The red LED illuminates and stays on when power is connected.
Built-in Ethernet connectivity. Connect any of the Ethernet ports found
on the transmitter or receiver for Internet access and to feed your
IP-enabled devices. You can also connect to an existing LAN to
integrate all IP-enabled devices connected to the Extender Set. When
properly connected, the yellow LED indicators blink and the green
indicators remain illuminated.
Connects to the HDBaseT port on the receiver via a single Cat5e/Cat6
cable.
Connects to the HDMI source device.
Infrared signal input. Collects infrared signals to be sent via HDBaseT to
the receiver (Rx) IR OUT.
Infrared signal input. Outputs infrared signals received from the receiver
(Rx) via HDBaseT.
RS-232 connector. Supports bi-directional RS-232 communication.
Connects to the power supply. (Not necessary if the receiver connects
with a power adapter.)
(5)
(6)
(7) (8) (9) (10) (11)
HDBaseT Extender Set 100m User Guide