Caldwell STRONG-BAC 20TB Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Sistemas de elevación Caldwell STRONG-BAC 20TB. Caldwell STRONG-BAC 20TB 11 páginas.

OPERATING

Operating

Falling Lifter.

Load loss.

Completely insert and securely fasten all pins, securely tighten all bolts before loading,

hoisting, or transporting the lifter, loaded or unloaded.

Falling load or lifter causes serious injury or death.

Lifting Cycle

1. Perform a preliminary test lift by hoisting the lifter several

inches off the floor, examining the lifter's performance. If the lifter's

performance is inadequate, remove the lifter from service. Then,

tag the lifter with an "Out of Service" tag. Inspect the lifter for any

damages or malfunctions. A qualified person shall correct any lifter

failures before returning to full service.

2. Verify the load is symmetrically attached to the lifter.

3. Verify the lifter's travel path is clear of people and any obstruction.

4. When the lifter's performance is optimal,

Proceed with the lifting cycle

5. Use only a vertical lift, hoist line is ninety degrees to horizontal.

6. Start raising the load slowly and gently.

7. Raise, lower, or transport the load ONLY over specified areas.

Proper Lifting

8. Avoid swinging the load—transport the load slowly.

9. Do NOT drag the load or lifter along the ground.

10. Do NOT allow the lifter to make any contact with any objects,

during loading, raising, transporting, or lowering .

11. Bumping the lifter, loaded or unloaded,

causes excessive swinging.

12. Do Not use shock loading or side loading.

13. Prohibit people from standing under a suspended lifter,

loaded or unloaded.

14. Prohibit operators from leaving a suspended lifter,

load or unloaded, unattended.

15. Set the load down gently.