Caldwell STRONG-BAC 20TS Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Sistemas de elevación Caldwell STRONG-BAC 20TS. Caldwell STRONG-BAC 20TS 11 páginas.

Imprimir página
Safety
•
Check your unit upon arrival, ensuring no damage
Receiving
or lost parts occurred, during transit. Contact the
carrier's agent, reporting any loss or damage.
•
Before
Read and understand this manual before
Operating
operating, inspecting, maintaining , or servicing
your Triangle Beam.
•
Allow only qualified persons to install, operate,
inspect, and maintain your Triangle Beam.
•
Confirm the Triangle Beam is
assembled correctly;
-adjustments correct for the load size and weight,
-and all components are securely fastened.
•
Perform a test lift before initial use
•
Operating
Inspect the load, making sure nothing can fall
from the load or lifter, during loading, lifting, or
transporting cycle—Remove any debris or loose
objects.
•
Inspect the lifter, verifying all equipment
adjustments are secure and correct for the
load size and weight.
•
Verify each operator is qualified or certified in
proper lifting and rigging techniques, refer to
ASME B30.9 Slings, B30.10 Hooks, and B30.26
Rigging Hardware.
•
Request each operator to demonstrate proper
lifting techniques, using the Triangle Beam.
•
Verify the travel path is clear.
•
Barricade people from swing zones, fall zones,
and crush zones.
•
Confirm the weight of the load does NOT exceed
your Triangle Beam's rated capacity.
•
Confirm the combined load and lifter weight
does NOT exceed the hoist's rated capacity.
Safety
Information
Operating
.
Lifting Cycle
4
•
Verify all lifting devices are free from twists,
kinks, or any damages.
•
Validate the lifter is correctly, completely seated
in the hoist.
•
Confirm the load's center of gravity is aligned
with the hoist center —before lifting or transport-
ing the loaded lifter.
•
Ensure the load can withstand forces applied by
the lifter.
•
Make sure the load is secure, preventing the
load from shifting, during the lift.
•
Do NOT lift loads over people.
•
Do NOT lift people.
•
Prohibit any person from riding on the load or
the lifter.
•
Obey stop signals from anyone.
•
Lift or transport only properly balanced loads.
•
Confirm the lifter, loaded or unloaded, is ready
for the hoisting or transporting cycle.
•
Verify the transport area is clear of people and
any physical obstructions before the lifting and
transporting cycles begin.
•
Accelerate and decelerate all loads slowly and
smoothly.
•
Do NOT lift an unsafe or unbalanced load.
•
Do NOT use a lifter labeled with an
"Out of Service" tag.
•
Use ONLY a vertical lift.
•
Lifting at angles less than or greater than 90
degrees voids your warranty.
•
Start lifting a loaded or unloaded lifter slowly
and gently.
•
Raise, lower, or transport the loaded or
unloaded lifter ONLY over specified areas.