Firetide HotPort 6102 Manual de instalación del hardware - Página 7
Navegue en línea o descargue pdf Manual de instalación del hardware para Hardware de red Firetide HotPort 6102. Firetide HotPort 6102 20 páginas. 6100 series
También para Firetide HotPort 6102: Manual de instalación rápida (2 páginas)
Imprimir páginaIndoor Node Installation
Indoor node installation is straightforward. Place the unit on a
Figure 1. AC Power Brick
table or shelf, or use the optional bracket to attach it to a wall, ceil-
ing, or cubicle partition. Attach the antennas, keeping in mind that
all antennas on all units should be parallel - typically vertical. Apply
power. The power LED should illuminate immediately; after about 60
to 90 seconds, the status LED should switch to steady green.
Firetide recommends that you power up and configure all nodes on
a table or bench before deployment. Use HotView or HotView Pro to
configure your mesh.
Figure . Optional Mounting Bracket
Note the location of the reset button in the lower right corner of the
rear panel. A paperclip can be used to reset the unit after it has fully
booted and the status light has come on.
Figure . HotPort 6100 Series Mesh Node - Front View
Figure . HotPort 6100 Series Mesh Node - Rear View
Firetide Instant Mesh Networks
February 2007