Direct Air RG52A3/BGEF Manual de instrucciones de instalación - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Mando a distancia Direct Air RG52A3/BGEF. Direct Air RG52A3/BGEF 8 páginas. Air conditioner remote controller
Imprimir página
Dehumidifying operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the
desired temperature.
can be set within a range of 17 C~ 30 C
2
in 1 C increments.
3
3. Press the ON/OFF button to start the air
ON/OFF
SHORT
CUT
conditioner.
1
MODE
TIMER ON
NOTE
TEMP
In the Dehumidifying mode, you can not switch the
FAN
TIMER OFF
fan speed. It has already been automatically controlled.
SLEEP
TURBO SELF CLEAN
LED FOLLOW ME
Adjusting air flow direction
Use the SWING
the desired airflow direction.
1. When push the SWING
louver changes 6 degree in angle for each push.
If pushing more than 2 seconds, the louver
will automatically swing up and down.
2. When push the SWING
louver changes 6 degree in angle for each push.
If pushing more than 2 seconds, the louver
will automatically swing left and right.
NOTE: When the horizontal/vertical louver swing
The temperature
O
O
O
and SWING
buttons to adjust
button, the horizontal
button, the vertical
or move to a position which would affect
the cooling or heating effect of the air
conditioner, it would automatically change
the swing/moving direction.
9 9
Timer operation
Press the TIMER ON button can set the auto-on
time of the unit. Press the TIMER OFF button
can set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-on
setting time and the signal "H" will be shown on
the LCD display area. Now it is ready to reset
the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired
ON/OFF
SHORT
CUT
Auto-on time. Each time you press the button,
MODE
1
TIMER ON
the time increases by half an hour between 0
TEMP
and 10 hours and by one hour between 10 and
2
FAN
TIMER OFF
24 hours.
SLEEP
3. After setting the TIMER ON ,there will be a one
second delay before the remote controller
TURBO SELF CLEAN
LED FOLLOW ME
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
controller shows TIMER OFF, the last Auto-off
setting time and the signal "H" will be shown on
the LCD display area. Now it is ready to reset
the Auto-off time to stop the operation.
2. Push the TIMER OFF button again to set
desired Auto-off time. Each time you press the
button, the time increases by half an hour
between 0 and 10 hours and by one hour
between 10 and 24 hours.
3. After setting the TIMER OFF ,there will be a
one second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "H " will disappear and the set temperature
will re-appear on the LCD display window.
10
10