AlcoMate Revo TS200 Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Equipos de prueba AlcoMate Revo TS200. AlcoMate Revo TS200 9 páginas. Digital personal breathalyzer
Imprimir página
Carefully use a flathead screwdriver (approx. 1/8" head width) to pry open the rear cover at the notch
located at the bottom. You can then fully remove the cover by separating it from the device along one of
the longer (vertical) edges. The rightmost image above shows the back of the device with rear cover fully
removed.
- Rear (Battery) Cover Removal -
- Rear (Battery) Cover Removal -
Remove the rear cover, then remove
the batteries. Use your finger to hold
down the small tab highlighted to the
left, and pull the sensor module
straight down. You can then simply lift
the module up from the device.
To install a new sensor module, place
the portion of the sensor module
highlighted to the left flush against
the section of the slot also
highlighted. You can then simply slide
the sensor module up into place, as
shown by the green arrow. Ensure the
tab is locked in place against the small
gray locking nub near the center of
the device.
4