Clarion APA2001 APA2001 APA2001 Manual del propietario y de instalación - Página 12

Navegue en línea o descargue pdf Manual del propietario y de instalación para Amplificador Clarion APA2001 APA2001 APA2001. Clarion APA2001 APA2001 APA2001 17 páginas. Mono amplifier
También para Clarion APA2001 APA2001 APA2001: Manual del propietario y de instalación (8 páginas), Manual de servicio (12 páginas)

Imprimir página

clarion

APA250145012001

SETTING THE GAIN

After completing the installation, follow these steps to set the Gain Control and then

perform the Final System Checks.

1. Tum the Gain Control all the way counter-clockwise.

2. Tum the vehicle's Ignition Switch to the ON position. Then tum the ON/OFF

Switch on the source unit to the ON position. Set all Tone or Equalization Controls to

"flat" positions and

turn

Loudness off.

3. Playa CD or Tape and set the Volume Control at 75% of full level.

NOTE: If the system uses an equalizer set all frequency controls to the "flat"

position.

4. Slowly increase the Gain Control. Stop when you hear a slight distortion of audio.

SETTING THE CROSSOVER

The Clarion amplifiers feature fully adjustable crossovers. To set the crossovers, fol-

low these steps:

1. Using the X-Over Mode Switch, select the desired mode: LP for Low Pass, HP for

High Pass or OFF for Full Range.

2. Using the Freq (Hz) Selection Control, select the desired frequency.

SETTING THE BASS BOOST

1. Initially set the Bass Boost control to its OFF position.

2. Listen to a variety of music styles (e.g., Rock, Rap, etc.) and switch the Bass Boost

control ON until a noticeable increase in low bass response is realized.

CAUTION: If you hear a "pop" (due to speaker over-excursion) adjust switch to

lower the Bass Boost to prevent speaker damage.