Alcorn Mcbride DMX OverRide Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Sistemas de control Alcorn Mcbride DMX OverRide. Alcorn Mcbride DMX OverRide 12 páginas.

Position

Input

SCENE1

SCENE2

SCENE3

RESUME

SCENE1

SCENE2

SCENE3

RESUME

Unit Connections

Connections to the DMX OverRide consist of the DMX I/O, Remote Control, and Power.

DMX Connections

The DMX OverRide is simply inserted into the DMX line between your lighting console,

playback device, or controller and your DMX-512 lighting network. The console or

controller output is plugged into the DMX OverRide DMX input, and the network

connects to the output. The unit is supplied with a 5-pin DMX patch cable to make it

easy to add the DMX OverRide into an existing installation.

Remote Control Connections

You can connect wires to the screw terminals on the rear of the DMX OverRide to

control the unit from a remote location. Be sure to set the DIP switches to match your

particular control scheme, either normally-open or -closed, and voltage or contact-closure

input.

The remote inputs operate with momentary activation (either momentarily closing with a

normally-open, or momentarily opening with a normally-closed configuration). Voltage

level input in voltage mode is any voltage between 5 to 24VDC. The inputs are protected

against reverse voltages and will not be damaged if this happens.

Power Input

The 5VDC power supply included with your DMX OverRide should be the only power

source you use with the unit. It is a universal switching type and is compatible with all

international and domestic power sources. The connector is a captive screw-type barrel

connector.

Right DIP Switch Bank - Input Configuration

OFF (UP)

Voltage Input

Normally Closed

ON (DOWN)

Contact Closure

Normally Open