Acond Hydromodul Grandis-N SP Manual de instalación - Página 13

Navegue en línea o descargue pdf Manual de instalación para Calentador de agua Acond Hydromodul Grandis-N SP. Acond Hydromodul Grandis-N SP 17 páginas.

Imprimir página

7.5 Electrical wiring and commissioning

It is electrically connected using the diagrams supplied with this manual. The electrical wiring

procedure is as follows:

1. Switch off the heat pump circuit breaker in the home switchboard.

2. By measuring the power cables, make sure that they are really disconnected from the

electrical.

3. Remove the front cover

a. Unscrew the two screws accessible from the bottom of the Hydromodule, see the

following figure.

b. Remove the lid by moving it up and then towards you.

4. Remove the control cabinet cover using four screws accessible from the front of the

Hydromodule, see the following picture.

5. Connect the cables to the terminal board, see the following picture according to the

attached diagrams.

Installation manual

Hydromodul