Clarion Ungo MS2004 Manual - Página 2
Navegue en línea o descargue pdf Manual para Alarma de coche Clarion Ungo MS2004. Clarion Ungo MS2004 17 páginas. Vehicle security system
También para Clarion Ungo MS2004: Manual del usuario (20 páginas)
Before You Begin
1. Be sure to read the manual thoroughly before beginning the installation to ensure a proper understanding of
the MS2004 and its functions.
2. Verify system contents:
q Main Unit
q Two 4-Button Remote Transmitters
q Siren
q Electronic Shock Sensor
q Harnesses
• 14-Pin Main harness
• 2-Pin Status LED harness
• 2-Pin Override Switch harness
• 5-Pin Door Lock harness
• 4-Pin Shock Sensor harness
3. Discuss the location of the status LED and the Emergency Override Switch with the vehicle's owner.
4. Discuss the optional features of the MS2004 and the features that must be programmed during installation,
with the vehicle's owner.
5. Check all of the vehicle's operating systems before and after the installation.
Installation Tips
1. Use a Volt / Ohm meter to test all wires. Do not use a test light.
2. Good power and ground connections are essential for proper operation. Ground the alarm as close to the
alarm main unit as possible.
3. Route all wires from the engine compartment to the interior of the vehicle through a grommet and use electrical
tape and/or split loom tubing for protection.
4. When adding optional accessories such as door locks, window modules, etc., be sure to fuse each additional
accessory power lead separately from the main power source. This will insure that the security system power
is retained in the event that an accessory malfunctions.
5. Avoid extending the system's wires, the supplied wiring harnesses provide sufficient length to connect to the
required vehicle circuits. If a wire must be extended, be sure to use the appropriate gauge wire in order to
avoid a drop in current. Always use wire that is at least the same gauge as the wire you are extending.
6. Never bypass the fuses included in the MS2004 wiring harness. They are necessary safety items designed to
protect both the system and the vehicle.
7. Be sure to perform a full function test of all of the systems components to verify proper operation. Also, be sure
to check all of the vehicle's operating systems before and after the installation.
8. For maximum security, disguise all system wires with black electrical tape and/or split loom tubing to prevent
a thief from being able to identify the system wiring.
Page 1 - MS2004 Installation Manual