Alde Compact 3010 Manual de servicio - Página 5

Navegue en línea o descargue pdf Manual de servicio para Caldera Alde Compact 3010. Alde Compact 3010 12 páginas.
También para Alde Compact 3010: Manual rápido (6 páginas), Manual de inicio rápido (4 páginas)

Imprimir página

REPLACING COMPONENTS

Always switch off the 12 V DC and 230 V ~ power supply, and turn the main gas cock to the off position before

starting any servicing. The seals (marked in red) must NOT be broken unless special permission has been obtai-

ned from Alde.

REPLACING THE PRINTED CIRCUIT

BOARD

1. Remove the service panel on the boiler.

. Detach the blue cable (marked Blue)(fig.1A) and brown cable

(marked Brown)(fig.1B), red cable (marked Red)(fig. 1C),

grey cable (marked Grey)(fig. 1D) and black cable (marked

Black)(fig. 1E) on the printed circuit board, and the blue

(marked PUMP-N) (fig.1F) and brown (marked PUMP-L)(fig.

1G) if the boiler is equipped with a 230V circulation pump.

. Release the white 6-point connection block (fig.1H) from the

sensors on the printed circuit board.

. Detach the white 4-point connection block (fig.1I) from the

fan on the printed circuit board.

. Detach the white 5-point connection block (fig.1J) from the

solenoid valve on the printed circuit board.

. Untight the hex-screw on the printed circuit board (fig. 1K).

7. Remove the printed circuit board by pressing together the

three hooks, (fig. 1L), and pulling out the circuit board.

8. Push the new circuit board firmly in and connect the cables

as shown in fig. 1.

9. NB! Tighten the hex-screw holding the printed circuit board

(fig 1K).

10.Refit the service panel and test-run the electrical heating

cartridge.

NB! Caution! Take preventative measures against static

electricity when handling the printed circuit board.

Static can damage the PCB.

Fig 1.

CABLE MARKINGS FIG.1

Blue cable, marked Blue on the printed circuit board.

Brown cable, marked Brown on the printed circuit board.

Red cable, marked Red on the printed circuit board.

Grey cable, marked Grey on the printed circuit board.

Black cable, marked Black on the printed circuit board.

Blue cable from pump marked, PUMP-N on the

printed circuit board.

Brown cable from pump marked, PUMP-L on the

printed circuit board

White 6-point connection block from the sensors.

White 4-point connection block from fan.

White 5-point connection block from solenoid.

REPLACING FAN

1. Remove the service panel on the boiler

. Release the cable from the fan motor by lifting the hook

(fig. 2A) and pulling the cable straight out.

. Release the plastic housing from the motor,

2 screws (fig 2B).

. Release the 4 plate screws (fig. 3A) securing the fan

to the fan housing.

. Lift the fan out of the boiler body.

. Fit the new fan by following these instructions in reverse.

NB! Take care not to damage the impeller when fitting

the fan.

7. Refit the service panel and test-run the boiler.

Fig .

Fig 10.