Xerox WORKCENTRE C2424 Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Impresora Xerox WORKCENTRE C2424. Xerox WORKCENTRE C2424 43 páginas. Copier-printer
También para Xerox WORKCENTRE C2424: Manual de consulta rápida (14 páginas), Folleto (8 páginas), Manual complementario (7 páginas), Especificaciones (6 páginas), Manual de introducción (26 páginas), Manual del usuario (21 páginas), Manual del usuario (20 páginas), Manual de mantenimiento (20 páginas), Manual del usuario (19 páginas), Manual de instrucciones (16 páginas), Manual (12 páginas), Manual de instrucciones (6 páginas), Manual de instalación (4 páginas), Manual de instalación (2 páginas), Kit de rodillos de alimentación de repuesto (2 páginas), Manual de instalación (2 páginas), Plantilla voluntaria de accesibilidad de los productos (10 páginas), Comparación de la competencia (3 páginas), Manual de consulta rápida (14 páginas), Manual de servicio (11 páginas), Manual de consulta rápida (13 páginas)

Connections and Internet Protocol (TCP/IP)

This section includes:

■

"Overview of Network Setup and Configuration" on page 6-2

"Choosing a Connection Method" on page 6-3

■

"Connecting via Ethernet (Recommended)" on page 6-3

■

"Connecting via USB" on page 6-4

"Configuring the Network Address" on page 6-5

■

"infoSMART Knowledge Base Documents (English only)" on page 6-8

This section includes connecting the multifunction system to the network via Ethernet or USB,

then configuring the system's TCP/IP or AppleTalk/EtherTalk address for the particular

network and operating system.

Overview of Network Setup and Configuration

Network connection and configuration steps are performed in the following order.

Turn the system and the computer On.

Connect the system to the network using the recommended hardware and cables.

Configure the system's network address, which is required to identify the system on the

network. Run the Installer on the WorkCentre C2424 Software CD-ROM to automatically

set the system's IP address, if the system is connected to an established TCP/IP network.

If you do not want to run the Installer to automatically set the IP address, you can do one

of the following:

■

For Windows operating systems, use TCP/IP to manually set the multifunction

system's IP address.

■

For Macintosh, use TCP/IP or AppleTalk/EtherTalk to set the system's network

address.

Install the driver software on the computer from the WorkCentre C2424 Software CD-

ROM. For information on driver installation, see the section in this chapter for the specific

operating system you are using.

Note

If the WorkCentre C2424 Software CD-ROM is not available, you can download the

latest driver from www.xerox.com/office/drivers.

Connections and Internet Protocol (TCP/IP)

WorkCentre® C2424 Copier-Printer

6-2