Xerox AltaLink B8075 Mantenimiento - Página 3

Navegue en línea o descargue pdf Mantenimiento para Impresora todo en uno Xerox AltaLink B8075. Xerox AltaLink B8075 4 páginas. Customer training
También para Xerox AltaLink B8075: Primeros pasos (14 páginas)

Imprimir página

Replacing the Fuser Module – Careful in this area may be HOT

Replacing the Transfer Roller - When the Transfer Roller is replaced you must reset the Supply

Counter.

1. Power off the device, then disconnect the power cord from

the device.

2. Remove any paper from Tray 5.

3. Open the left side door of the device.

4. Locate the transfer roller in the printer side door. It is

labeled R4.

5. To remove the used transfer roller, squeeze the orange tabs

at both ends of the transfer roller and lift the transfer roller

out of the printer.

6. Unpack the new transfer roller. Retain the packaging.

7. To install the new transfer roller, position the transfer roller

in the side door as shown. Squeeze the orange tabs at both

ends of the transfer roller and press down gently, until it clicks

into place.

8. Place the used transfer roller in the packaging that came with the new transfer roller.

9. Close the left side door of the device.

10. Reset the supply life counter. To reset the counter manually:

1. Touch Device and then Tools.

2. Touch Device Settings and then in the Features list, touch Supplies > Supply Counter

Reset.

3. Touch Transfer Roller and then Reset Counter. The Reset Confirmation Counter screen is

displayed.

4. To reset the counter, touch Reset. The counter is set to 100% remaining.

5. Close the window.

1. Power off the device, then disconnect the power cord from the

device.

2. Remove any paper from Tray 5. Open the left side door of the

device.

3. Locate the fuser module in the side of the printer. It is labeled R3.

4. To release the fuser module, rotate the orange thumbscrews

counterclockwise. The thumbscrews are at each end of the fuser

module.

5. Pull out the used fuser module.

6. Unpack the new fuser module. Retain the packaging.

7. Insert the new fuser module.

8. To fasten the fuser module, rotate the orange thumbscrews

clockwise.

9. Place the used fuser module in the packaging that came with the

new fuser module.

10. Close the left side door of the device. Reconnect the device to the

power cord, then power up the device.