Xerox ColorQube 89 Series Manual de configuración - Página 8
Navegue en línea o descargue pdf Manual de configuración para Impresora todo en uno Xerox ColorQube 89 Series. Xerox ColorQube 89 Series 12 páginas. Usb card reader configuration guide for workcentre 51 series, workcentre 6400, workcentre 56 series, workcentre 75 series, workcentre 57 series, workcentre 77 series, colorqube 87 series, colorqube 89 series, colorqube 92 series, colorqube 93 series
También para Xerox ColorQube 89 Series: Manual (32 páginas)
Imprimir página9. Configure [Accounting Information] If the Job Based Accounting option has been purchased, these
fields will be available for selection. Choose whether the server will enter the appropriate accounting
code or whether the user will be prompted to enter a code.
10. Fill in the [Device Instructional Blocking Window] details; the Window Title and Instructional Text.
For example "Please swipe your card to log on".
11. Select [Save]
If the USB Card Reader Detection Policy was set to [Prevent use of device when USB card reader is
disconnected] then when the summary screen appears, it will indicate whether an Approved card reader
is Connected, Not Connected or Not Supported.
Verify Connected Reader
At this point the local UI should show a pop up or message indicating that the card reader is not
connected.
1. Insert a qualified card reader into the USB port and observe that the message goes away.
2. Remove the card reader and observe that the pop up reappears.
3. Plug the card reader back in.
Validation
At this point the system is fully configured for authentication. Lock a few services to verify that
authentication is required for access.
1. Via CWIS, navigate to [Properties] –[Security] – [Authentication] – [Tools & Feature Access]
2. Under Presets, select [Custom Access]
3. Select [Locked] for any Services, Features, or Pathways that should be secured.
4. Select [Apply]
At the local UI, navigate to a locked Service or Pathway. Verify the prompt to swipe a card to log on is
displayed.
5. Swipe or scan a valid card with the USB card reader
a) Depending on the particular reader you should observe the card reader LED change color or
the reader will beep.
b) Observe that the user is authenticated and their username appears in the upper right corner
of the local user interface display.
6. Swipe or scan the same card with the card reader
a) Depending on the particular reader you should observe the card reader LED change color or
the reader will beep.
b) Observe that the user is logged out and that the Default Walkup Screen is displayed. If the
Default Screen is locked, the blocking screen will be displayed.
6 USB Card Reader Configuration Guide