Xerox 460 Manual de instalación rápida - Página 17
Navegue en línea o descargue pdf Manual de instalación rápida para Copiadora Xerox 460. Xerox 460 38 páginas. Macintosh driver information
También para Xerox 460: Manual de información (13 páginas)
Imprimir página
Microsoft Windows 2000 LPR and IPP Printing Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and
perform the procedure here.
Your Document Centre now has DHCP, LPR,
and NetBIOS over the IP protocol enabled by
default. If your DHCP server will provide host
name, IP address, Gateway address, and Sub-
net Mask, the Document Centre TCP/IP infor-
mation will be configured on initial boot.
This means that if you have configured your
DHCP server with the desired information, you
may connect your Document Centre to your net-
work and go right to the section on the back of
this card entitled Go to the Server/Workstation
and....
You can use BOOTP or RARP servers to assign
TCP/IP information to your Document Centre.
Refer to the DHCP/BOOTP and RARP Quick
Install cards for details.
If you are not using Dynamic Addressing, record
the following TCP/IP information:
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
Go to the printer and...
1.
Connect your Document Centre to the
network with the appropriate cabling
2.
Enter the Tools pathway
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
4.
Enable the Protocol and Media
a)
Press the TCP/IP Settings button.
b)
Press the Protocol and Media button.
c)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
NOTE: The Broadcast Address will be calcu-
lated automatically.
5.
Set the Host Name
Page 1
a)
Press the Name/Address button.
b)
One at a time press the soft buttons on
the Touch Screen for each octet of the
IP address and enter the numbers
using the keypad.
c)
Press the Host Name button.
d)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes and exit to the
TCP/IP Settings Screen.
6.
Set the Subnet Mask and Gateway
a)
Press the Subnet and Gateway
button.
b)
One at a time press the soft buttons on
the Touch Screen for each octet of the
Subnet Mask and enter the numbers
using the keypad. Repeat this process
for the IP Gateway address. When
finished press Save to record the
changes and exit to the TCP/IP
Settings screen.
c)
Press the TCP/IP - Line Printer
button. At the next screen press
Enable then press Save.
NOTE: While you can change the port num-
ber at which your Document Centre will
accept lpr print jobs, it is recom-
mended that you do this ONLY with
extreme caution as most lpr spoolers