Xerox 470 Manual de instalación rápida - Página 11

Navegue en línea o descargue pdf Manual de instalación rápida para Copiadora Xerox 470. Xerox 470 38 páginas. Macintosh driver information
También para Xerox 470: Manual de información (13 páginas)

Imprimir página
Xerox 470 Manual de instalación rápida
RARP Dynamic TCP/ IP Address Assignment Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and follow
the instructions.
NOTE: By default, DHCP is enabled on the
Document Centre. This card will show you
how to disable DHCP (or enable it if it was
disabled) and set your TCP/IP information
using RARP.
Your Document Centre can retrieve the following
values from a RARP server:
TCP/IP Address
Subnet Mask
Gateway Address
Consult the documentation supplied with your
RARP server software to verify what TCP/IP
information it is capable of supplying.
Go to the RARP server and...
1.
Configure the RARP or BOOTP server
with the TCP/IP information you want
assigned to your printer.
Go to the printer and...
2.
Connect your Document Centre to the net-
work with the appropriate cabling.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
3.
Enter the Tools pathway.
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
4.
Enter the Network Setup menus.
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
5.
Enable TCP/IP printing.
a)
Press the TCP/IP Settings button.
b)
Press the Protocol and Media button.
c)
Press the Enable button. If Physical
Media buttons appear, select Ethernet
or Token Ring. Press Save.
d)
Press the Dynamic Addressing
button. At the next screen select
RARP and press Save.
Page 1
6.
Press the Exit Tools button. The device
will reboot.
a)
Obtain the Configuration Report
page from your printer. Verify the
Document Centre printer TCP/IP
information was assigned correctly by
the RARP server.
b)
Repeat Steps 3a-5a then go to step 7.
NOTE: The Broadcast Address will be calcu-
lated automatically.
7.
Set the Host Name (skip steps 7a-7c if your
RARP server supplies this information).
a)
Press the Name/Address button.
b)
Press the Host Name button.
c)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes and exit to the
TCP/IP Settings Screen.