Xerox Fiery X12 Uso manual - Página 10
Navegue en línea o descargue pdf Uso manual para Accesorios para impresoras Xerox Fiery X12. Xerox Fiery X12 12 páginas. Controller interface kit
T
O REASSEMBLE THE
Power switch
Power connector
Mouse
Keyboard
Monitor
Copier interface (scan)
Copier interface (print)
(not used)
10/100BaseT
6
Using the Fiery X12/Fiery X40 Advanced Controller Interface Kit
F
X12/F
IERY
IERY
1. Reseat all boards, cables, connectors, and other parts loosened or removed during
inspection or service.
2. Place the Fiery X12/Fiery X40 in its standard operating position.
3. Place the side panel onto the Fiery X12/Fiery X40 so the grooves on the bottom of the
side panel fit into the grooves in the tray.
Be careful not to damage any ribbon cables; if necessary, fold the ribbon cables inside the
tray before replacing the side panel.
4. Close the side panel. Two clips on the top edge of the panel will click when it is properly
installed.
5. Replace the screw that secures the side panel.
Do not leave the Fiery X12/Fiery X40 side panel off after servicing. An airflow
N
:
OTE
channel is created by the side panel and the fan. Leaving the Fiery X12/Fiery X40 open
could reduce the operational life expectancy of internal Fiery X12/Fiery X40
components.
6. Connect any cables removed during service to the back of the Fiery X12/Fiery X40.
7. Connect the monitor, keyboard, and mouse to the back of the Fiery X12/Fiery X40.
8. Connect the monitor power cable to the back of the monitor (some monitors may already
have this cable attached).
X40