Federal Communication Commision Compliance
This equipment has been tested and found to comply with the limits set for a
Class B digital device, as stated in Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
commercial installation. This equipment generates, uses, and may radiate
radio frequency energy. If not installed and used in accordance with the
instructions provided, this equipment may cause disruptive interference to
nearby radio and television communications. Even if the equipment is
installed according to the instructions, there is no guarantee of no
interference in a particular installation. If this equipment does cause
disruptive interference to nearby radio and television reception, switch the
equipment off to determine if it is the true cause of the interference. If the
equipment is the cause of the interference, the user should try to minimize
the interference by taking one or more of the following courses of action:
Note
Installation of the Finisher and/or the Token Ring Interface
results in an FCC classification change to Class A.
Either re–orient or relocate the radio/television receiving antenna.
Increase the separation between the equipment and the radio/television
receiver.
Connect the equipment to an AC outlet that is not on the same circuit as
the radio/television receiver.
If the previous solutions fail to bring results, you should consult either your
equipment dealer or an experienced radio/television technician.
For more information on interference, refer to the Federal Communications
Commission's booklet "How to Identify and Resolve Radio-TV Interference
Problems."
This booklet is available from the U.S. Government Printing Office,
Washington D.C. 20402, Stock No. 004-000-00345-4.
viii
Phaser 7700 Color Printer Service Manual
Imprimir página