Xerox Nuvera 100 Manual de planificación - Página 19

Navegue en línea o descargue pdf Manual de planificación para Software Xerox Nuvera 100. Xerox Nuvera 100 22 páginas. Production system
También para Xerox Nuvera 100: Hoja de especificaciones (2 páginas), Características Manual (34 páginas), Manual del usuario (40 páginas), Manual de instrucciones (34 páginas), Manual de referencia (2 páginas), Manual de planificación (20 páginas), Manual de referencia (42 páginas), Referencia rápida (2 páginas), Manual de instalación (2 páginas), Manual complementario (48 páginas), Manual de planificación (38 páginas), Manual de planificación (16 páginas), Manual de referencia (2 páginas), Especificaciones (2 páginas), Manual de consejos y sugerencias (18 páginas), Manual de consejos y sugerencias (18 páginas), Manual de introducción (26 páginas), Manual de introducción (30 páginas)

Xerox Document Binder 120-D (DB120-D)

4. Xerox Nuvera 100 / 120 Digital Production System

•

A Finisher Transport Module is required for in-line

connectivity to the printer.

•

Coated paper is functional with the 860mm input height but

not recommended for the 1021mm input height. However,

binding test could be done and binding strength

confirmed/checked before start of job/production.

•

When connected inline with a printer, the minimum binding

capacity is 2 sheets of 20 lbs (75 gsm) bond paper. (In walk-

up manual mode, the minimum binding capacity is 1 sheet

20 lbs (75 gsm) bond paper.

•

The DB120-D is compatible with 8.5 x 11" (A4 in Europe)

paper in weights ranging from 20 – 110 lbs (75 – 200 gsm)

bond and flush cut tabs.

Note: Weights above 32 lbs (120 gsm) should only be used as

covers, dividers or inserts.

Listed below are the dependencies and prerequisites for

installing the DB120-D.

•

The Finisher Transport Module is required for in-line

connectivity to the printer.

•

Currently, a Xerox Document Stacker 5000 must be installed

in-line with the printer and the DB120-D.

•

If the DB120-D is installed in-line with another Finishing

Device (such as a DS5000), the 1021 Height Kit must be

installed (unit is shipped with 860 Height Kit installed).

•

If there is a transition of an existing (stand alone or from a

different printer) DB120-D to a Nuvera Digital Production

System, the DB120-D will require an upgrade.

Note: In case the floor at the customer site is very uneven, it is

recommended that the Nuvera IOT is installed and leveled with a

Caster Leveling Kit (kit number 498K07900).

4-1