Xerox DocuColor 8000 Manual de planificación - Página 19

Navegue en línea o descargue pdf Manual de planificación para Servidor de impresión Xerox DocuColor 8000. Xerox DocuColor 8000 22 páginas. European harmonic current notice
También para Xerox DocuColor 8000: Manual de uso (2 páginas), Boletín informativo (2 páginas), Boletín informativo (1 páginas), Procedimiento de limpieza (2 páginas), Manual de referencia (4 páginas), Manual de introducción (40 páginas), Folleto (14 páginas), Instrucciones de uso (1 páginas), Manual (10 páginas), Manual complementario (6 páginas), Manual (13 páginas), Aviso (1 páginas)

Imprimir página
Xerox DocuColor 8000 Manual de planificación
Xerox Document Binder 120-D (DB120-D)
4. Xerox Nuvera 100 / 120 Digital Production System

Limitations

System Dependencies and Prerequisites

•
A Finisher Transport Module is required for in-line
connectivity to the printer.
•
Coated paper is functional with the 860mm input height but
not recommended for the 1021mm input height. However,
binding test could be done and binding strength
confirmed/checked before start of job/production.
•
When connected inline with a printer, the minimum binding
capacity is 2 sheets of 20 lbs (75 gsm) bond paper. (In walk-
up manual mode, the minimum binding capacity is 1 sheet
20 lbs (75 gsm) bond paper.
•
The DB120-D is compatible with 8.5 x 11" (A4 in Europe)
paper in weights ranging from 20 – 110 lbs (75 – 200 gsm)
bond and flush cut tabs.
Note: Weights above 32 lbs (120 gsm) should only be used as
covers, dividers or inserts.
Listed below are the dependencies and prerequisites for
installing the DB120-D.
•
The Finisher Transport Module is required for in-line
connectivity to the printer.
•
Currently, a Xerox Document Stacker 5000 must be installed
in-line with the printer and the DB120-D.
•
If the DB120-D is installed in-line with another Finishing
Device (such as a DS5000), the 1021 Height Kit must be
installed (unit is shipped with 860 Height Kit installed).
•
If there is a transition of an existing (stand alone or from a
different printer) DB120-D to a Nuvera Digital Production
System, the DB120-D will require an upgrade.
Note: In case the floor at the customer site is very uneven, it is
recommended that the Nuvera IOT is installed and leveled with a
Caster Leveling Kit (kit number 498K07900).
4-1