Direct Supply EZ-LIFT WHEELCHAIR SEAT Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Silla de ruedas Direct Supply EZ-LIFT WHEELCHAIR SEAT. Direct Supply EZ-LIFT WHEELCHAIR SEAT 20 páginas.

Imprimir página

STEP 3a – Install Lift Mechanism

(Optional seat height adjustment for some installations)

Follow these directions if your lift seat mechanism is interfering with the cross bars on your wheelchair

and additional clearance height is needed. Always verify that a higher seating height is appropriate for the

user before placing the wheelchair into use.

Note that this operation will increase the wheelchair's seating height

and will also require a higher bumper mounting height for the anti-rollback device.

a. Remove the lift seat mechanism from the

wheelchair and set on a work surface.

b. Using a 1/2 inch wrench, remove the two

bolts connecting the mounting hook to the

adjustable slide bar. (figure 7)

c. Adjust the hook to the low, middle, or high

position:

Lowest Hook Height = Higher seat height

and more clearance (figure 8)

Highest Hook Height = Lower seat height

and less clearance (figure 9)

d. Rethread both bolts and tighten snugly using

a 1/2 inch wrench.

e. Check the fit on your wheelchair and readjust

using Steps 1-4 if necessary.

f. Complete all steps listed in Step 3 of this

manual before proceeding.

•

WARNING: All four of the seat's hooks must

be set to the same height to ensure correct

function.

Installation Instructions

(cont.)

Figure 7

Figure 8

Figure 9