Alderon Industries VersAlarm I/O VLIO-00005 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Sistema de seguridad Alderon Industries VersAlarm I/O VLIO-00005. Alderon Industries VersAlarm I/O VLIO-00005 20 páginas. Indoor/outdoor alarm panel
También para Alderon Industries VersAlarm I/O VLIO-00005: Manual de inicio rápido (2 páginas)
Imprimir página
VersAlarm™ I/O - USER GUIDE
Installation
DISCONNECT ALL POWER SOURCES WHEN INSTALLING OR SERVICING THIS PRODUCT. FAILURE TO
TURN OFF ALL POWER SOURCES COULD RESULT IN SERIOUS INJURY OR DEATH.
Mounting Enclosure and Alarm Float Switch
STEP 1: WALL MOUNT ENCLOSURE
Determine the mounting location for the VersAlarm™ I/O. Make
sure the power outlet is within six feet of the alarm panel for the
pre-installed power cable. Hold the VersAlarm™ I/O up to the
desired mounting location, mark the drill hole locations. Once
marked, drill pilot holes for screws (not included) and use wall
mount anchors (not included) if necessary. Place enclosure in
the mounting location, adjust until the pilot holes are lined up
with the enclosure and fasten screws to secure the alarm panel
in place.
STEP 2: DETERMINE ACTIVATION LEVEL
The alarm panel comes with a pre-installed power cable and
alarm float switch. Refer to the instructions that came with the
alarm float switch to determine the alarm activation level and
mount the alarm float switch. See step 3 for proper installation
of the alarm float switch.
Note: If using auxiliary contacts, see Wiring step 1 instructions.
CAUTION: Do not connect power until installation/wiring is
complete and the alarm is ready for testing.
6 | Alderon Industries™ - Leading Edge Control Products
Mount alarm float switch
at alarm activation level
Plug power cable into
230VAC receptacle