eControls Smart WHF Control WTTKWF Manual del instalador - Página 2
Navegue en línea o descargue pdf Manual del instalador para Unidad de control eControls Smart WHF Control WTTKWF. eControls Smart WHF Control WTTKWF 4 páginas. Wall control and wifi control
Imprimir página
Step 4. Feed Cable to Gang Box
If the optonal TS3J Outdoor
Temperature Sensor is being
installed, install it now. (See the
TS3J Installer Guide.)
Feed the other ends of the cable from
the FC3J and the TS3J (if installed)
through the wall and the opening in the
gang box. Insert the gang box into the
wall opening and secure.
Step 5. Install the WFM Plug-In Module
Make sure the Plug-In Module is
oriented with the SILVER chip side up
as illustrated. Use the guide to insert
the module.
Step 6. Power the Fan
Apply power to the fan. If the fan automatically starts up,
remove power and check the wiring. If the problem persists,
contact us.
Step 7. Connect the Cable(s) to WTT
If a sensor is installed, connect the
cable with the "YELLOW" marker
into the "YELLOW" connector.
Connect the cable with the "RED"
marker into the "RED" connector.
The LCD display should be lit. If
l W T T
M o d e
not, check the connector.
Verify that WIFI is flashing on the WTT. This
indicates that the WFM module is plugged into
the WTT correctly. If WIFI is not flashing, verify
that the WFM is oriented correctly (SILVER
side up) and that it's plugged in completely.
Step 8. Attach the WTT and Wall Plate
Attach the WTT wall control to the plastic gang box using the
screws provided. Attach the wall plate to the WTT using the
screws provided in the wall plate.
Step 9. Set the Number of Fan Speeds
The WTT is factory set to a two speed fan. For three-speed or
one-speed fan installations, the number of fan speeds available
needs to be changed to reflect the type of fan installed.
To change the number of speeds, PRESS and HOLD
until the first option is displayed. PRESS
display the number of speeds. PRESS
fan or PRESS
Module is
SILVER side up.
Step 10. Checking the Installation
CHECK FAN OPERATION
PRESS
PRESS
CHECK FAN SPEEDS
Verify that the fan is running in High speed. For a 3-Speed fan,
PRESS
to Medium (M). PRESS
the fan speed to Low (L). PRESS
to return to High (H) speed.
For a 2-Speed fan, PRESS
lower the fan speed to Low (L). PRESS
PRESS
PRESS
RETURN TO TEMPERATURE CONTROL
PRESS
TEMPERATURE CONTROL.
WIFI
Indoors
Cool
Set
To
SPEED
H
OFF
Step 11. Connecting WFM to Home Network
Refer to the WFM Homeowner Quickstart manual for setting up
the account and connection the WFM to the home WiFi
network.
to set a 1-speed fan.
then press
to select TIMER CONTROL.
MODE
to turn the fan ON. Fan should be running.
ON/OFF
then PRESS
SPEED
then PRESS
SPEED
SPEED
SPEED
to return to High (H) Speed.
to turn the fan OFF.
ON/OFF
MODE
then PRESS
to select
MODE
again to
MODE
to set a 3-speed
to lower the fan speed
to lower
then PRESS
then PRESS
to
then
SPEED