Yamaha AW4416 Manual complementario

Navegue en línea o descargue pdf Manual complementario para Instrumentos musicales Yamaha AW4416. Yamaha AW4416 1 páginas. Installing an internal hard disk
También para Yamaha AW4416: Tutorial (34 páginas), Manual complementario (20 páginas), Suplemento del manual (48 páginas), Manual (3 páginas)

Imprimir página

! Important !

Limitations on simultaneous

use of I/O cards

The rear panel of the AW4416 has two OPTION I/O slots,

allowing you to install various I/O cards that are compatible

with the Yamaha Mini YGDAI format.

The combinations of I/O cards shown in the table below can-

not be installed in the AW4416's OPTION I/O slots 1/2 and

used simultaneously. (However, the Y56K card can be used in

combination with the three models marked by a

Combinations of I/O card that cannot be used together

AP8AD

(Apogee

Corporation)

MY8-TD

MY8-AT

MY8-AE

MY4-AD

MY8-AD

MY4-DA

AP8AD

AP8DA

Y56K

: Can be used together

Using cards together in violation of the above restrictions will

cause the AW4416 to be damaged. You must observe the

restrictions described above. Please be aware that if an

impermissible combination of cards is used inadvertently,

Yamaha Corporation will take no responsibility for the dam-

age that will occur.

If an impermissible combination of I/O cards is used inadvert-

ently, a message of "CANNOT USE BOTH SLOTS!!" will

appear in the display, either as shown in the form shown in 1

or 2, below.

Message 1

symbol.)

AP8DA

Y56K

(Apogee

(WAVES

Corporation)

— You must read this —

Message 2

If you continue using the AW4416 in this state, it will be dam-

aged.

Turn off the power in the following sequence.

1. The monitor system connected to the output jacks of the

AW4416

2. The AW4416 itself

3. Storage devices connected to the SCSI connector of the

AW4416, and external sound sources connected to its

input/output jacks.

You must perform the shutdown procedure (Operation Guide

p.17) before you turn off the power of the AW4416.

However if display message 1 is shown, you will be unable to

perform the shutdown procedure, so make sure that the access

indicator located at the left of the level meter/counter is not lit,

and then turn off the power.

Do not turn on the power until a permissible combination of

I/O cards is installed.

• The limitation on the use of I/O cards is not dependent on

the version of the AW4416's operating system. However,

please be aware that if you are using an operating system

version earlier than V2.0, the error messages shown above

may not appear.

• This document ("You must read this") is current as of Octo-

ber 2001. To conﬁrm operation of option I/O cards that

become available in the future, refer to the AW4416 home

page www.aw4416.com.

• If you have questions regarding this matter, please consult

your Yamaha dealer.