Yamaha DTX500K Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Instrumentos musicales Yamaha DTX500K. Yamaha DTX500K 48 páginas. Drum trigger module

Yamaha DTX500K Manual del usuario
1

Connections

In this chapter, you'll learn how to set up the DTX500. Read these instructions carefully and in
the following order to ensure that the instrument sounds and operates properly:
1 Connecting the Pads → 2 Setting Up the Power Supply (p. 10) → 3 Connecting to Speakers or Head-
phones (p. 10) → 4 Turning the Power On (p. 11) → 5 Selecting the Trigger Setup (p. 12)
You'll need to change the Trigger Settings of the DTX500 according to the type of drum set you are using. If the
setting is not appropriate, problems may occur—such as improper sound, or inappropriate volume balance
among the pads.
Refer to the "Selecting the Trigger Setup" section on page 12 on how to select the appropriate setup.

1 Connecting the Pads

Referring to the illustration below, connect the output cable from
each pad to each Trigger Input jack located on the rear panel of
the DTX500. For details, see the Assembly Manual that comes
with the drum set you are using.
CAUTION
• To prevent electric shock and damage to the devices,
make sure the power is switched OFF on the DTX500 and
all related devices before making any connections to the
DTX500's input and output jacks.

Setting up with Acoustic Drums

The DTX500 can be played from an acoustic drum kit if the kit is
fitted with an optional set of drum triggers (such as Yamaha DT20
Drum Triggers) and the triggers are properly connected to the
input jacks of the DTX500.

2 Setting Up the Power Supply

A special power source adaptor supplies power to the DTX500.
2-1. Make sure that the
set to the standby (?) position.
2-2. Connect the DC plug of the included AC power adaptor to
the DC IN terminal on the rear panel.
To prevent the cord from being unplugged accidentally,
wrap the cord around the cable clip and secure it.
10
DTX500 Owner's Manual
!! IMPORTANT !!
Standby/On Switch of the DTX500 is
CAUTION
• Make sure that the power adaptor's cord is not bent at an
extreme angle when wrapping the cord around the clip.
Doing this can damage or sever the cord and create a fire
hazard.
2-3. Connect the other end of the power cord to an AC outlet.
WARNING
• Please use the specified AC power adaptor. The use of
any other adaptors may cause irregular operation or
damage to the device.
• Only use the voltage specified as correct for the DTX500.
The required voltage is printed on the name plate of the
DTX500.
CAUTION
• Unplug the AC Power Adaptor when not using the
DTX500, or during electrical storms.
3 Connecting to Speakers or
Headphones
Since the DTX500 has no built-in speakers, you'll need an exter-
nal audio system or a set of stereo headphones to properly moni-
tor it.
Monitor system for the DTX series
MS100DR, MS50DR, etc.
OUTPUT L/MONO and R jacks
Headphones
PHONES jack