Yamaha YCHS7018 Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Instrumentos musicales Yamaha YCHS7018. Yamaha YCHS7018 10 páginas. Chimes & chime stand
Imprimir página
Preparation Before Playing
Play the chimes on a flat, level surface.
In YCH7018 and YCHS7018, if some sound tubes are
in contact with the damper felt while releasing the
damper, adjust the four casters according to the
steps below.
In YCH6018, if some sound tubes are in contact with
the damper felt even while the damper is released,
place the chimes on a flat, level surface.
For the YCHS7006, place the chimes where all sound
tubes are not in contact with the guide plate.
Sound tube
Damper felt
Adjusting the Height of the Casters
(YCH7018, YCHS7018)
1.
Turn the lock nut on upper of the caster
counterclockwise to release the height lock.
2.
Turn the bolt cap of each caster using the
included tuning key to adjust the chimes
height from the floor.
Turning it clockwise raises the height away from the
floor, while turning it counterclockwise lowers it
toward the floor.
3.
After the height is adjusted, turn the lock nut
clockwise to lock the height.
Tuning key
Bolt cap
Lock nut
8 • YCH7018 YCH6018 YCHS7018 YCHS7006 Owner's Manual
In contact
Height adjustment
required
Adjusting the Damper Pedal (YCH7018,
YCH6018, YCHS7018)
The damper holds the sound tubes with the damper felt to shorten the
reverberation of the chime sound. While pressing the damper pedal,
the damper is released and reverberations are heard. When you stop
pressing the damper pedal, the damper will work and the reverberation
will stop.
The position of the damper pedal can be adjusted by
the following steps.
1.
Loosen the fixing bolt.
2.
Adjust the position of the damper pedal.
3.
Tighten the fixing bolt to fix the damper
pedal.
Damper pedal
Using the damper stopper
You can keep the damper release by pushing in the
damper stopper while pressing the damper pedal. To
release the damper stopper, press the damper pedal
again.
NOTE
• When the depth of pressing the pedal is insufficient, the
damper stopper cannot be pushed in. In this case, adjust the
damper pedal position so that you can fully depress the pedal.
Damper stopper
Fixing bolt