Yamaha CRX-D430 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Receptor Yamaha CRX-D430. Yamaha CRX-D430 26 páginas. Cd receiver

Imprimir página

Basic operation of this unit

Turning on the power

Press 1 STANDBY/ON (or A STANDBY/ON) to

turn on this unit.

Press it again to set this unit to the standby mode.

• You can select whether to display the clock (ECO OFF mode)

or not (ECO ON mode) when this unit is in the standby mode.

Press and hold I TIME MODE during standby mode until

"ECO OFF" or "ECO ON" appears.

• To charge your iPod while this unit is in the standby mode,

select "ECO OFF".

• The memory back-up circuit prevents the clock setting from

being lost even if this unit is in the standby mode. However, the

clock setting will be lost if the power cable is disconnected from

the AC wall outlet or if the power supply is cut off for more than

four minutes.

• In the standby mode, this unit consumes a small amount of

power.

Selecting an input source

Press one of the input selector buttons (2)

repeatedly (or press N INPUT) to select the

input source from CD, iPod, TUNER (FM/AM/

DAB), and AUX.

• Press DBAND (or E BAND) to select FM, AM, or

DAB.

• For details on CD, iPod, and tuner operations, refer to

pages 8, 10, 12, and 14.

• When you select AUX, this unit outputs sound played

back on the component which is connected to the AUX

IN jacks. While AUX is selected as the input source,

this unit does not output signals at the AUX OUT

jacks.

Adjusting the volume level

Press K VOLUME + (or rotate O VOLUME

clockwise) to increase the volume level and

press KVOLUME – (or rotate it counter-

clockwise) to decrease it.

Muting the sound

Press LMUTE.

To restore audio output to the previous volume level, press

it again or press KVOLUME +/–.

En y The circled numbers and alphabets correspond to the ones on the attached sheet.

Basic operation of this unit

Adjusting sounds

Press I FUNCTION (or K FUNCTION).

Press 0

repeatedly (or rotate the

multi jog dial ( J )) to select the setting from

"Bass" (low frequency), "Treble" (high

frequency), and "Balance" (speaker balance),

and then press 0ENTER (or push the multi

jog dial ( J )).

Press 0

repeatedly (or rotate the

multi jog dial ( J )) to adjust the setting and

then press 0 ENTER (or push the

multi jog dial ( J )).

The setting ranges are as follows:

Bass ..................... –10 dB to +10 dB

Treble................... –10 dB to +10 dB

Balance ................ L +6 to R +6

Note

These settings have no effect on the audio signals output at the

AUX OUT jacks and the DIGITAL OPTICAL OUT jack.

Listening through the headphones

Connect the headphone plug to the H PHONES

jack.

While headphones are connected, the sound from the speakers

and subwoofer is cut off.

Changing the brightness of the

display

Press 4 DIMMER repeatedly.

You can select the brightness level from bright, mid dim,

and dim.