Yamaha HTR-5130 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Receptor Yamaha HTR-5130. Yamaha HTR-5130 42 páginas. Natural sound av receiver

Imprimir página

For U.K. customers

If the socket outlets in the home are not suitable for the plug

supplied with this appliance, it should be cut off and an

appropriate 3 pin plug fitted. For details, refer to the

instructions described on the right.

Note: The plug severed from the mains lead must be

destroyed, as a plug with bared flexible cord is hazardous if

engaged in a live socket outlet.

NOTES ABOUT THE REMOTE CONTROL TRANSMITTER

Battery installation

Battery replacement

When you notice a decrease in the operating range of the

remote control transmitter, the batteries are weak. Replace

both batteries with new ones.

Notes

Use only AA, R6, UM-3 batteries for replacement.

Be sure the polarities are correct. (See the illustration inside

the battery compartment.)

Remove the batteries if the remote control transmitter will

not be used for an extended period of time.

If batteries leak, dispose of them immediately. Avoid

touching the leaked material or letting it come in contact with

clothing, etc. Clean the battery compartment thoroughly

before installing new batteries.

Special Instructions for U.K. Model

IMPORTANT

THE WIRES IN MAINS LEAD ARE COLOURED IN

ACCORDANCE WITH THE FOLLOWING CODE:

Blue: NEUTRAL

Brown: LIVE

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured markings

identifying the terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the

terminal which is marked with the letter N or coloured

BLACK. The wire which is coloured BROWN must be

connected to the terminal which is marked with the letter L

or coloured RED. Making sure that neither core is

connected to the earth terminal of the three pin plug.

Remote control transmitter operation range

Remote control

sensor

Notes

There should be no large obstacles between the remote

control transmitter and the main unit.

If the remote control sensor is directly illuminated by strong

lighting (especially an inverter type of fluorescent lamp,

etc.), it might cause the remote control transmitter not to

work correctly. In this case, reposition the main unit to avoid

direct lighting.

–dB

Within approximately

6 m (19.7 feet)