Yamaha A-S201 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Amplificador Yamaha A-S201. Yamaha A-S201 34 páginas. Integrated amp

Imprimir página

■ REC jacks

• The REC jacks output audio signals of the currently

selected input (except when LINE 2 is selected).

• Volume level, tone control, balance and Pure Direct

settings do not affect the REC jacks.

■ Connecting speaker cables

1 Remove approximately 10 mm of insulation from the

end of each speaker cable.

2 Twist the bare wires of the cable firmly together.

3 Unscrew the knob.

4 Insert one bare wire into the hole in the side of each

terminal.

5 Tighten the knob to secure the wire.

Red: positive (+)

Black: negative (–)

■ Connecting via banana plug

(Except for Asia, U.K. and Europe

models)

1 Tighten the knob.

2 Insert the banana plug into the end of the

corresponding terminal.

Banana plug

CAUTION

Speaker impedance must be set as shown below.

Speaker connection

SPEAKERS A or

SPEAKERS B

SPEAKERS A and

SPEAKERS B

Bi-wiring

Speaker impedance

8 Ω or higher

16 Ω or higher

(except for North

America model)

8 Ω or higher

■ Bi-wire connection

Bi-wire connection separates the woofer from the

combined midrange and tweeter section.

A bi-wire compatible speaker has four binding post

terminals. These two sets of terminals allow the speaker to

be split into two independent sections. With these

connections, the mid and high frequency drivers are

connected to one set of terminals and the low frequency

driver to another set of terminals.

Rear panel

Connect the other speaker to the other set of terminals in

the same way.

Note

When making bi-wire connections, remove the shorting bridges

or cables on the speaker.

To use the bi-wire connections, press SPEAKERS A and

SPEAKERS B on the front panel so that both SP A and B light up

on the front panel display.

Connecting power cable

Plug the power cable into an AC wall outlet after all other

connections are complete.

CAUTION

Only for General model:

Before connecting the power cable, make sure you set

VOLTAGE SELECTOR of this unit according to your

local voltage. Improper setting of VOLTAGE SELECTOR

may cause fire and damage to this unit.

CONNECTIONS

Speaker

To the AC wall

outlet with the

power cable