Yamaha AG-Stomp Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Amplificador Yamaha AG-Stomp. Yamaha AG-Stomp 32 páginas. Yamaha accoustic guitar/pre-amplifier owner's manual
También para Yamaha AG-Stomp: Manual de servicio (45 páginas), Lista de parches (1 páginas), (neerlandés) Manual (32 páginas)

Imprimir página

Using the AG-Stomp

First, connect your guitar to the AG-Stomp and try to get some sound.

I Connecting the Guitar

Before making any connections, make sure the AG-Stomp's power is off, set the AG-Stomp's OUTPUT

knob to "0" and the +9V SUPPLY switch to "OFF". Then connect the INPUT jack on the rear panel to the

guitar's output jack with any commercially available guitar cable (monaural ↔ monaural).

Never connect the guitar to the AG-Stomp with the supplied TRS phone cable when the Guitar Power Supply

function described below is not used. If the TRS phone cable is used and the +9V SUPPLY switch is switched

"ON", it may result in damage since a total of 18V will be supplied to the electric-acoustic guitar's built-in pre-

amplifier. Also, if the +9V SUPPLY switch is set to "OFF", the electric-acoustic's built-in pre-amplifier may func-

tion abnormally.

G Guitar Power Supply

Before supplying power to your guitar, make sure

that the guitar's pre-amplifier battery has been re-

placed with the dummy battery supplied with the

AG-Stomp. Leaving the 006P 9V battery in place will

result in the guitar's electronics receiving 18V of

power, causing damage.

The AG-Stomp is capable of supplying power to your elec-

tric-acoustic guitar's built-in pre-amplifier via the supplied

TRS phone cable. Power is supplied to the electric-acoustic

guitar when the AG-Stomp's power is switched ON.

This function is possible as long as your electric-acoustic

guitar meets the following conditions:

• The guitar uses a monaural output.

• The guitar uses a 006P 9V battery to supply power

to the guitar's built-in pre-amplifier.

• The power to the guitar's built-in pre-amplifier is

switched ON/OFF by connecting/disconnecting the

cable at the guitar's jack.

• The guitar's built-in electronics consume 10mA of

power, or less.

Replace the electric-

acoustic guitar's pre-

amplifier battery with the

dummy battery.

OFF (

)

[Setting]

1. Replace the electric/acoustic guitar's built-in pre-ampli-

2. Before making any connections, turn off the AG-Stomp's

3. Use the supplied TRS phone cable to connect the AG-

* When the AG-Stomp's power is ON, make sure that the MUTE

* Do not connect effectors, etc., between the AG-Stomp's IN-

Dummy Battery

Set the +9V SUPPLY

(supplied)

switch to the "ON"

position.

TRS Phone Cable (supplied)

fier battery with the dummy battery supplied with the

AG-Stomp.

power and make sure its OUTPUT knob is set to "0",

then set the +9V SUPPLY switch to "ON".

Stomp's INPUT jack to the output jack on your electric/

acoustic guitar.

switch on the AG-Stomp is held down when connecting/dis-

connecting the cable.

PUT jack and the electric-acoustic guitar's OUTPUT jack.

Power will not be supplied to the electric-acoustic guitar's

built-in pre-amplifier if the AG-Stomp and the electric-acoustic

guitar are not directly connected.

If the AG-Stomp's power

is ON, hold the MUTE

switch when making

connections.