Yamaha AV-90PY Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Amplificador Yamaha AV-90PY. Yamaha AV-90PY 25 páginas. Natural sound digital sound field processing amplifier 5 speaker configuration

Imprimir página

CONNECTING SPEAKERS

aConnect the SPEAKERS terminals to your speakers with wire

of the proper gauge, cut to be as short as possible. If the

connections are faulty, no sound will be heard from the

speakers. Make sure that the polarity of the speaker wires is

correct, that is, + and – markings are observed. If these wires

are reversed, the sound will be unnatural and will lack bass.

Do not let the bare speaker wires touch each other and do

not let them touch the metal parts of this unit as this could

damage this unit and/or speakers.

Use speakers with the specified impedance shown on the

rear of this unit.

ABOUT THE ACCESSORY TERMINALS

AC OUTLETS

Use these to connect the power cords from your components

to this unit.

The power to the SWITCHED outlets is controlled by this unit's

POWER switch or the provided remote-control transmitter's

POWER key. These outlets will supply power to any

component whenever this unit is turned on.

The maximum power (total power consumption of

components) that can be connected to the SWITCHED AC

OUTLETS is 100 watts.

REMOTE CONTROL (PHONO) connector

If you have a YAMAHA turntable with the

it to this connector by using the cable provided with the

turntable. This connection allows you to control the turntable

from the provided remote control transmitter.

GND terminal (For turntable use)

Connecting the ground wire of the turntable to this terminal will

minimize hum, but in some cases better results may be

obtained with the ground wire disconnected.

How to Connect:

Red: positive (+)

Black: negative (–)

FRONT OUT terminals

These terminals are for front-channel line output. Leave the

jumper bars connected to FRONT IN terminals when you use

the built-in amplifier.

However, if you drive front speakers with an external stereo

power amplifier, remove the jumper bars and connect input

terminals of the external amplifier (MAIN IN or AUX terminals

of a power amplifier or an integrated amplifier) to these

terminals.

FRONT IN terminals

These terminals are for line input to the built-in front-channel

amplifier. Leave the jumper bars connected to FRONT OUT

mark, connect

terminals when you use the built-in amplifier.

However, if you drive front speakers with an external stereo

power amplifier, remove the jumper bars.

CENTER OUT terminal

This terminal is for center-channel line output. There is no

connection to this terminal when you use the built-in amplifier.

However, if you drive a center speaker with an external power

amplifier, connect input terminal of the external amplifier to this

terminal.

If you use the built-in amplifier and the external power amplifier

at the same time, the sound will be output through both

speakers.

1 Press and hold the tab.

2 Insert the bare wire.

[Remove approx. 5mm

(1/4") insulation from

the speaker wires.]

3 Release the tab and

secure the wire.