Directechs DB3 Manual de instalación - Página 13

Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles Directechs DB3. Directechs DB3 20 páginas. 2011 subaru outback - 403.subaru2 1.25
También para Directechs DB3: Manual de instalación (19 páginas), Manual de instalación (19 páginas), Manual de instalación (20 páginas), Manual de instalación (10 páginas), Manual de instrucciones (17 páginas)

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

Wait until the LED turns ON solid red.

Note: To skip the transponder programming and use convenience features only, press

the programming button 5 times. Wait until the LED turns ON solid orange, then

proceed with step 2.

Insert and turn the first key to the ON position. The LED starts flashing green. Wait at

least 3 seconds, but no more than 10 seconds, then remove it.

If the transponder programming was skipped, the LED turns ON solid orange for 3

seconds then shuts OFF when programming is done.

Within 5 seconds:

Insert and turn the second key to the ON position. The LED starts flashing orange.

Wait at least 3 seconds, but no more than 10 seconds, then remove the key.

Within 5 seconds:

Press the programming button. The vehicle ignition will be triggered. The LED turns ON

solid green for 3 seconds, then turns OFF once the module has been successfully

programmed.

You have successfully completed the module programming sequence.

Wait until the LED turns ON solid red.

Open an Internet Explorer browser (version 6 or higher), and go to

www.directechs.com. The detail of the platform and firmware that is currently saved on

the interface module will be indicated in the top left corner of the page.

Reconnect the module wiring to the vehicle first, and only then, plug the harnesses to

the module without pressing the programming button. The LED turns ON solid red.

Insert and turn the key to ON and OFF twice. The LED starts flashing orange,

indicating that it is ready for the next step.

Remove the module from the vehicle, and reconnect it to your computer. The web site

will automatically recognize that you are moving onto the second phase of the

programming sequence.

Click on Submit Key2GO Request.

Once the configuration is completed, reconnect the module. The LED flashes once

orange, and then turns ON solid green for 3 seconds.

You have successfully completed the module programming sequence.

403.FORD4 3.13 2016 Ford Transit Connect