Clark Synthesis Prosound429 Manual de instalación - Página 4

Navegue en línea o descargue pdf Manual de instalación para Transductor Clark Synthesis Prosound429. Clark Synthesis Prosound429 9 páginas.

MOUNTING BRACKET INSTALLATION

The Prosound429 is most-commonly mounted using the mounting bracket assembly (see diagram

below). This assembly, which comes with the Prosound429, is easily installed on a variety of surfaces.

1. To install this assembly, determine the location for the mounting bracket (insure the placement

of the bracket allows for adequate spacing for the Prosound429. On drum thrones, insure the

Prosound429 will not hit the stand once it is mounted). Secure the mounting bracket using screws.

2. Next, insert the threaded stud into the threaded hole on the mounting bracket. Insure the stud is

turned into the bracket at least 8 or 9 full revolutions (maximum of 10 revolutions).

3. Spin two jam nuts onto the threaded stud, tightening one nut down against the mounting bracket

to insure the threaded stud is secured to the bracket.

4. Finally, place the Prosound429's brass mounting nut onto the threaded stud. Insuring not to

crossthread the brass nut, gently turn the Prosound429 5 to 6 complete revolutions. If you feel

resistance, stop immediately. CAUTION: DO NOT OVERTIGHTEN. Spin the jam nut on the stud

down to the brass nut and, using two wrenches (one on the jam nut and one on the brass nut),

tighten the jam nut against the brass nut.

CAUTION: DO NOT TIGHTEN THE JAM NUT TO THE BRASS NUT BY TURNING THE Prosound429. THIS

WILL RESULT IN SEVERE DAMAGE TO THE Prosound429 AND WILL VOID THE WARRANTY.

SIDE VIEW

Jam Nuts

Thumper

Prosound429

MOUNTING BRACKET ASSEMBLY

Mounting Bracket

Threaded Stud

BOTTOM VIEW