Clark-Reliance GL53 Instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación para Equipos de iluminación Clark-Reliance GL53. Clark-Reliance GL53 4 páginas. Illuminator
Imprimir páginaWorld's Leader in Boiler
Trim Instrumentation
Note: Make sure that the power is turned off to
the supply wiring before connecting the
illuminator.
Tools needed:
– Slotted Screwdriver
– 1/2" Wrench
1. Open the illuminator housing by loosening
the three hex head cap screws on the end of the
unit that secures the Conduit/Lamp assembly in
place.
2. Carefully remove the assembly and remove
the Frosted Lamp (B) from the illuminator
housing and set aside. The lamp is 60W on 120
VAC models and 50W on 230VAC models.
3. Loosen the screw (C) from the side of the
lamp socket/conduit connector that holds the
assembly in place on the pipe nipple.
4. Take the lamp socket/conduit connector
assembly (D) off of the housing end piece and
set the housing aside.
5. Disassemble the lamp socket/conduit
connection assembly by removing the two
screws (E) from inside of the lamp socket. (Note
that there are two small washers on the
assembly screws. Do not lose these washers as
they are needed for re-assembling the
illuminator.)
7. Connect the black wire to the 'gold' screw
terminal on the bottom of the lamp socket.
8. Connect the white wire to the 'silver' screw
terminal on the bottom of the lamp socket.
9. Re-assemble the lamp socket/conduit
connector assembly using the same two screws
with washers inside of the lamp socket. Make
sure that the mounting plate is centered on the
lamp socket/conduit connector assembly.
16633 Foltz Parkway, Strongsville, OH 44149 USA
Telephone: (440) 572-1500
Fax: (440) 238-8828
www.clark-reliance.com
10. Thread the lamp socket/conduit
connector assembly back into the bottom
of the pipe nipple and tighten the holding
screw.
11. Carefully screw the lamp into the
socket and re-assemble the bottom
assembly back onto the illuminator
housing (make sure that the gasket
between the bottom assembly and
housing is in place). Secure by tightening
the three hex head cap screws on the
bottom side of the housing.
12. Wire the illuminator to the 120 V.*
power supply. (*Unless lamp is for 230 V.
service)
Section:
Bulletin:
Date:
Supercedes:
Page 3