Directed Xpresskit DBALL-NISS08EU Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles Directed Xpresskit DBALL-NISS08EU. Directed Xpresskit DBALL-NISS08EU 10 páginas.

Imprimir página
Platform: DBALL2
Firmware: NISS08EU

Module Programming

Refer to the LED Diagnostics section on page 10 for more information and for troubleshooting purposes.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit
available functions and features.
1. Connect the interface module to your computer using the XKLoader.
2. Open an Internet Explorer browser (version 6 or higher), and go to www.xpresskit.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top left corner of the page.
3. Select the year, make and model of the vehicle; the page will refresh to display the compatible firmware.
4. In the search result page, select one of the available install options (config for RSR, RXT or Standard install), and follow the
instructions provided on the screen.
5. Once you have configured your options, click on the FLASH button to upload the firmware onto the interface module.
6. The following message will be displayed when the upload is completed:
"The flashing is successfully completed. You may now unplug the kit."
You can now proceed with the programming instructions below.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
OR
W2W Installation
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
1
Wait until the LED turns ON solid red.
For Type 1 vehicles
Press PTS once to turn ignition ON. The LED will turn
2
ON solid green for 3 seconds, then shuts OFF.
For Type 2 vehicles
2
Turn ON Ignition using Key
3
The LED turns ON solid green for 3 seconds, then turns OFF
once the module has been successfully programmed.
4
Turn the Ignition OFF.
th
4
st
1
st
1
ENGINE
&
1X
PUSH
START
STOP
Key
Rev.: 20200502
Page 5
rd
3
nd
2
rd
3
nd
2
Solid
&
Solid
Off
x 3 sec.
&
START
Flashes
&
Solid Green
OFF
x3 secs
Key OUT
START
© 2020 Directed. All rights reserved.