Clarke 3110847 Manual de instrucciones de uso y mantenimiento - Página 7
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Herramienta eléctrica Clarke 3110847. Clarke 3110847 8 páginas. Air ratchet wrench
También para Clarke 3110847: Instrucciones de uso y mantenimiento (17 páginas)
Imprimir página
Employers are advised to refer to the HSE publication "Guide for Employers".
All hand held power tools vibrate to some extent, and this vibration is transmitted to the operator
via the handle, or hand used to steady the tool. Vibration from about 2 to 1500 herz is potentially
damaging and is most hazardous in the range from about 5 to 20 herz.
Operators who are regularly exposed to vibration may suffer from Hand Arm Vibration Syndrome
(HAVS), which includes 'dead hand', 'dead finger', and 'white finger'. These are painful
conditions and are widespread in industries where vibrating tools are used.
The health risk depends upon the vibration level and the length of time of exposure to it......in
effect, a daily vibration dose.
Tools are tested using specialised equipment, to approximate the vibration level generated under
normal, acceptable operating conditions for the tool in question. For example, a grinder used at
45° on mild steel plate, or a sander on softwood in a horizontal plane etc.
These tests produce a value'a', expressed in metres per second per second, which represents the
average vibration level of all tests taken, in three axes where necessary, and a second figure 'K',
which represents the uncertainty factor, i.e. a value in excess of 'a', to which the tool could
vibrate under normal conditions. These values appear in the declaration on page 7.
You will note that a third value is given in the specification - the highest measured reading in a
single plane. This is the maximum level of vibration measured during testing in one of the axes,
and this should also be taken into account when making a risk assessment.
'a' values in excess of 2.5 m/s
tool with a vibration value of 2.8 m/s
whereas a tool with a value of 11.2 m/s
The graph below shows the vibration value against the maximum time the respective tool may
be used, per day.
The uncertainty factor should also be
taken into account when assessing a
risk. The two figures 'a' and 'K'may
be added together and the resulant
value used to assess the risk.
It should be noted that if a tool is used
under abnormal, or unusual
conditions, then the vibration level
could possibly increase significantly.
Users must always take this into
account and make their own risk
assessment, using the graph as a
reference.
Some tools with a high vibration value, such as impact wrenches, are generally used for a few
seconds at a time, therefore the cumulative time may only be in the order of a few minutes per
day. Nevertheless, the cumulative effect, particularly when added to that of other hand held
power tools that may be used, must always be taken into account when the total daily dose rate
is determined.
HAND-ARM VIBRATION
2
are considered hazardous when used for prolonged periods. A
2
may be used for up to 8 hours (cumulative) per day,
2
may be used for ½ hour per day only.
- 7 -