ALDI FERREX 704518 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Sierra ALDI FERREX 704518. ALDI FERREX 704518 20 páginas. 1010w

Belt adjustment control

WARNING! Wear eye protection before carrying out a belt

adjustment.

WARNING! Ensure the product is disconnected from the mains

power supply before attempting any

operation.

Turn the machine upside down, hold it firmly with

one hand, start the belt sander and then release

the on/off trigger (4) immediately after observing

tracking of sanding belt. If the belt runs outward,

turn belt adjustment control knob (8) anti-

clockwise and clockwise if belt runs inward (Fig. E).

Adjust the belt until the the belt is in the centre of

the base plate. Belt life will be greatly increased by

keeping the tracking adjustment set properly.

WARNING! Ensure the product is

disconnected from the mains power

supply before attempting any operation.

WARNING! keep your fingers clear of

the belt while sanding.

When sanding tight corners, you can use the front

plate (13) to get the better sanding result (Fig. F1).

Lift the front plate (13) up to the locked position.

You do not need to hold it during sanding while

the front plate (13) is locked in place (Fig. F2).

If your belt sander becomes too hot, especially when

used at low speed, set the speed to maximum and

run with no load for 2-3 minutes to cool the motor.

Avoid prolonged usage at very low speed.

Always use a sanding belt (11) suited to the material you wish to sand.

Always ensure the work-piece is firmly held or clamped to prevent movement.

Support large panels close to the sanding area.

AFTER SALES SUPPORT

1300 889 028

(toll free)

1010W Belt Sander

MODEL No.: PBS101.A • 02/2021 • 704518