Directed AS-1774 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Arranque a distancia Directed AS-1774. Directed AS-1774 16 páginas.
Imprimir página
Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the CRANK position.
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user's intervention for arming). By default, your
Remote Car Starter is configured to Passive Mode.
Passive mode:
To arm the Starter Kill, press the
button on the transmitter, OR
1.
In Passive Mode, the Starter Kill will automatically arm 1 minute (by default) or 3
minutes (if configured this way) after the ignition is turned OFF or once the last door is
closed (if the doors are monitored).
2.
The LED on the antenna will flash quickly during the countdown preceding the activation
of the Starter Kill.
3.
Once the activation countdown expires, the LED will send a series of quick double
flashes to indicate that the Starter Kill is now armed.
To disarm the Starter Kill, press the
button on the transmitter.
x
The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes (if
configured this way) if no door is left opened (if the doors are monitored) and the ignition
is not turned ON.
Active Mode:
To arm the Starter Kill, press the
button on the transmitter.
1.
The parking lights will flash once.
2.
The LED on the antenna will flash slowly.
3.
If remote door locks are installed, this will also lock the doors and arm the OEM-style
alarm.
To disarm the Starter Kill, press the
button on the transmitter.
1.
The parking lights will flash twice.
2.
The LED on the antenna will remain OFF.
3.
If remote door locks are installed, this will also unlock the doors.
Remote-Starting Your Vehicle
Setting Your Vehicle into Ready Mode
If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON
(RUN) position.
User guide
P.5