Clarke CAT209 Instrucciones de uso y mantenimiento - Página 3

Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Herramienta eléctrica Clarke CAT209. Clarke CAT209 9 páginas. Air blow gun

COMPRESSED AIR REQUIREMENTS

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF

COMPRESSORS AND COMPRESSED AIR SUPPLY.

Use only clean, dry, regulated compressed air as a power source.

Air compressors used with the tool must comply with the appropriate

European Community Safety Directives.

A build-up of moisture or oil in the air compressor will accelerate wear and

corrosion in the tool. Ensure any moisture is drained from the compressor daily

and the inlet filter is kept clean.

If an unusually long air hose is required, (over 8 metres), the line pressure or the

hose inside diameter may need to be increased.

The air hose must be rated at least 150% of the maximum operating pressure of

the tool.

A typical air line layout is shown above. If an automatic in-line filter/regulator is

used, it will keep the tool in good condition, but should be regularly checked.

For optimum performance it is recommended that a 3/8" ID hose is used.

DO NOT exceed the maximum operating pressure for the tool. It is

recommended that air pressure to this tool does not exceed 90 psi (6.2 bar) at

the tool. Higher pressure and dirty air will shorten the life of the tool due to

faster wear and is a possible safety hazard

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]