Clarke CHT880 Instrucciones de uso - Página 3

Navegue en línea o descargue pdf Instrucciones de uso para Herramienta eléctrica Clarke CHT880. Clarke CHT880 4 páginas. Long/short arm threaded nut riveters

Imprimir página

FITTING THE MANDREL

1. Remove the sheath,

locking ring and washer.

2. Slide the spring-loaded

sleeve down to expose the

hex shank

3. Screw your chosen your

chosen mandrel into the

hex shank as far as possible.

4. Release the sleeve.

• The sleeve will spring back

over the lower part of the

mandrel.

5. Replace the sheath,

locking ring and washer.

6. Fit the mandrel nut, finger

tight, and tighten the locking ring.

SETTING THE STROKE

• Model CHT880 has a stroke scale

to help achieve optimum

compression of the rivet. The rivet

nut needs to shorten

approximately 6mm during

compression when using

M6,M8,M10 & M12 rivets. Smaller

rivets may require a smaller

setting.

1. Set the angle of the arms so that

the scale reads 6mm.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]