Clarke CIWLI300 Instrucciones de uso y mantenimiento - Página 10

Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Herramienta eléctrica Clarke CIWLI300. Clarke CIWLI300 17 páginas.

WARNING: ENSURE THAT THE CORRECT SOCKET IS BEING USED FOR THE

NUTS ON YOUR PARTICULAR VEHICLE. AN INCORRECT SOCKET SIZE IS

LIKELY TO DAMAGE THE HEADS OF THE BOLTS/NUTS.

NOTE: As the battery becomes discharged, the power available will

drop.

3. After use, recharge the battery pack as shown on page 8. Avoid leaving

the batteries in a discharged state.

TIGHTENING A NUT

1. Start the nut by hand, ensuring it is not cross threaded, then with the

appropriate socket fitted to the wrench, place it on the nut.

2. With the FORWARD/NEUTRAL/REVERSE switch-bar in the clockwise

(FORWARD ARROW) running position, and holding the wrench firmly in

BOTH HANDS, pull the trigger.

3. Run each nut up in turn until it is 'nipped' up only - do not tighten. When all

nuts are nipped up, tighten progressively by pulling the trigger fully and

allowing the action to operate as little as possible to prevent over-

tightening.

4. ALWAYS finish tightening with a torque wrench.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]