Clarke CPR2 Instrucciones de uso y mantenimiento - Página 8
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Herramienta eléctrica Clarke CPR2. Clarke CPR2 13 páginas. Oil free riveter
Imprimir página1. Unscrew and remove the head assy (item 2).
2. Using the wrench supplied, hold the jaw housing coupler (item 7), undo the
locknut (item 8).
3. Place the 56mm gauge (on the edge of the wrench provided), alongside
the jaw housing assembly (item 35 inset), and screw the jaw assy in or out,
so that the lip of the gauge is in line with the end face of the jaw housing
(item 3.) Secure in position with the locknut (item 8).
Additionally, following prolonged use, the jaws may fail to grip the mandril
effectively, and will therefore need replacing. Dis-assemble the jaw housing
assembly, and re-assemble using genuine parts supplied from your nearest
CLARKE dealer, ensure you carry out the adjustment above.
SERVICE AND REPAIR
If the tool runs erratically or becomes inefficient although the air supply is in
good order, it may be necessary to dismantle the tool. Such servicing and
repair work should be carried out by qualified service technicians.
PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline
moisture or restrictions in the air-line, or the use of connectors of improper size
or poor condition which will reduce air supply.
Grit or gum deposits inside the tool may also reduce its efficiency. This
condition can be corrected by cleaning out the air strainer and flushing out
the tool with gum solvent or oil, or failing this, the motor may require
dismantling.
**Clarke Air Line Oil (part no. 3050825) is available from your CLARKE dealer.
STORAGE
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
Clarke air line oil into the air inlet, and run the tool for 5 seconds in order to
lubricate the internal parts.
When not in use, disconnect from air supply, clean tool and store in a safe, dry
place.
ACCESSORIES
A wide range of accessories is available including filter/regulators, lubricators,
high-pressure hoses (5 to 50 metres) etc.
Contact your CLARKE dealer for further information or CLARKE International
Service Department on 01992 565333.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8