Zanussi ZBB28651SA Manual del usuario - Página 25

Navegue en línea o descargue pdf Manual del usuario para Frigorífico Zanussi ZBB28651SA. Zanussi ZBB28651SA 48 páginas. Refrigerator zanussi zbb28651sa
También para Zanussi ZBB28651SA: Manual del usuario (16 páginas)

Zanussi ZBB28651SA Manual del usuario
Climate
Ambient temperature
class
T
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre

Electrical connection

• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not
observed.
• This appliance complies with the E.E.C.
Directives.

Ventilation requirements

The airflow behind the appliance must be
sufficient.
min.
5 cm
200 cm
www.zanussi.com
2
min.
200 cm
2

Installing the appliance

Make sure that the mains cable can
move freely.
1. If necessary cut the adhesive sealing strip
and then apply it to the appliance as shown
in figure.
x
x
2. Push the appliance in the direction of the
arrows (1) until the upper gap cover stops
against the kitchen furniture.
3. Push the appliance in the direction of the
arrows (2) against the cupboard on the
opposite side of the hinge.
2
1
4. Make sure that the distance between the
appliance and the cupboard front-edge is
44 mm.
4mm
44mm
The lower hinge cover (in the accessories bag)
makes sure that the distance between the
appliance and the kitchen furniture is correct.
5. Make sure that the clearance between the
appliance and the cupboard is 4 mm.
6. Open the door. Put the lower hinge cover in
position.
7. Attach the appliance to the niche with 4
screws.
25